2011-07-01, 06:00 PM
I was testing an attr routine. I launch it with pokeing it and randomize usr 60000.
When returns to basic, the problem is if I put a single print, then returns out of memory.
Not this if I put a print at.
I think the compiler affects to variables ch add or something.
command line:
zxb attr1a.bas -T -B -a -Z -O1 --org 32768
Regards.
When returns to basic, the problem is if I put a single print, then returns out of memory.
Not this if I put a print at.
I think the compiler affects to variables ch add or something.
Code:
Sub GetAddrTileFull(y, x, buf)
Dim attraddr as UInteger
attradr = AttrAddr(y, x)
POKE buf,peek(attradr-32)
POKE buf+1,peek(attradr-31)
POKE buf+2,peek(attradr-30)
POKE buf+3,peek(attradr+2)
POKE buf+4,peek(attradr+34)
POKE buf+5,peek(attradr+34+32)
POKE buf+6,peek(attradr+34+31)
POKE buf+7,peek(attradr+34+30)
POKE buf+8,peek(attradr+34+29)
POKE buf+9,peek(attradr+2+29)
POKE buf+10,peek(attradr-1)
POKE buf+11,peek(attradr-33)
End Sub
Dim x,y as uinteger
x=peek 23421
y=peek 23422
GetAddrTileFull(y,x,23400)zxb attr1a.bas -T -B -a -Z -O1 --org 32768
Regards.
