2013-04-13, 02:57 AM
Code:
asm
jr ZXBASICBorielVersionEnd
db "ZX Boriel BASIC version 1.3.0s983"
ZXBASICBorielVersionEnd:
end asm
CLS
SAVE "SAVETEST"CODE 49152,256
PRINT
PRINT "LOAD 1"
LOAD "SAVETEST"CODE
PRINT
PRINT "LOAD 2"
LOAD "SAVETEST"CODE 49152
PRINT
PRINT "LOAD 3"
LOAD "SAVETEST"CODE 49152,256
PRINT
PRINT "LOAD 4"
LOAD "SAVETEST "CODE ' ten chars
PRINT
PRINT "LOAD 5"
LOAD "SAVETEST "CODE ' 11 chars
PRINT
PRINT "LOAD 6"
LOAD ""CODE
PRINT
PRINT "LOAD 7"
LOAD "SAVETESTx"CODEI did test it with the above code and it works and thank you for the fixes.
It went through 1 - 6 and failed at #7 but I did expect #4 to fail and if not that then at least #5 but it did not.
It works fine except for this odd behaviour. It is the same behavior as with the original BASIC but the original
in case #5 accepts the load command but fails to load while the compiled BASIC loads it without a hitch, that
is the only difference I see between the two. It does not make sense in my view to load with 11 chars when
10 is the maximum. I do not mind case #4.