IM 2

[na_th_an]

I do: the ISR saves all the register pairs. Check the code and see

But that's not the problem. The problem occurs with bank switching. Just with bank switching, even if I don't enable my ISR or even don't enable IM2, any bank switching messes subsequent PRINT calls. Minimal case scenario:

Code:

' Test Asm ; Permorm some dummy paging di ld a, 5 ld bc, $7ffd out (c), a ; now RAM 5 is in. xor a ld bc, $7ffd out (c), a ld ($5b5c), a ei ; back to normal End Asm Print "HOLA";

Compile and run this in either 128 BASIC or USR 0 mode. You won't see "HOLA" on screen, but a bunch of trash.

So no clue? That's bad I really need PRINT, in fact I'm doing this in BASIC 'cause I can print to the screen with no hassle.

Also, the aplib decompressor also messes up something. Whenever I use it (not only with this project), the PRINT output gets BOLD.